24
Daily
• Keep the machine clean.
• Check the saw blade for missing teeth and
cracks (see fig 36).
• Spray oil the bare metal surfaces.
Weekly
• Open the top & bottom wheel covers and clean out
all saw dust.
Clean out impacted ‘crud’ & saw dust
Clean out impacted ‘crud’ and saw dust
Monthly
• Open the lower and upper door and check the
condition of the tyres and the drive belt (see figs
36-37).
• Clean impacted ‘crud’ from the tyres, apply a little
oil to the screw threads of the blade and drive belt
tensioners. DO NOT USE OIL near the belt.
• The pivots and the slides of the top wheel mounting
assembly and the captive stub axle of the belt
tensioner in its slot could likewise be lightly oiled.
• Using an air line (wearing goggles) blow out the
motor casing.
Fig 36-37
• Check for missing teeth (a)
• Check the condition of the tyres (b)
• Check the condition of the drive belt (c)
a
b
c
Oil
To Next Page