Axxera AXV820 - Bluetooth Operation

32
AXV820
Bluetooth Operation
Before you can use a Bluetooth device, it must be paired
and connected. Make sure that Bluetooth is activated on
your device before you begin the pairing process.
The AXV820 broadcasts the pairing signal constantly
when no devices are currently connected. Complete the
        
       
The device name is "AXV820"
The Bluetooth passcode "1234"
Note          
pairing is performed.
Most Bluetooth devices support the auto-connect feature
and will connect automatically if the device is in range
when the AXV820 is powered-on.
If your device was previously paired but does not connect,
e         

         
down arrows to scroll through the list of devices. Press
desired device name, then press "Connect" to connect the
device.
To disconnect a device, enter the Bluetooth setup menu

          
the desired up and down arrows to scroll through the
list of devices. Press desired device name, then press
"Disconnect" to connect the device.
To permanently delete a device, enter the Bluetooth setup

         
Use the desired up and down arrows to scroll through
the list of devices. Press desired device name, then press
"Delete" to connect the device.
Preparation
P
airing a New Device
Connecting a
Paired Device
Disconnecting a
Device
Deleting a
Paired Device
Pairing a Device