Axxess ASWC-1 Instructions

Congratulations, your vehicle will be auto-detected by the
ASWC-1.
ASWC-1 Connections
1) Connect the Black wire of the ASWC-1 to chassis ground.
2) Connect the Red wire of the ASWC-1 to a 12-volt accessory wire, one that turns on
and off with the ignition key.
3) Connect the Green/Orange wire of the ASWC-1 to pin 7 of the vehicle. Below is a
picture of what the connector in the vehicle looks like:
This is the pin view of the connector in the vehicle
4) Connect the Black/Green wire of the ASWC-1 to pin 8 of the vehicle.
5) Connect pin 6 of the vehicles harness to chassis ground. You may use the same chassis
ground as the black wire.
6) All other wires on the ASWC-1 please tape up, they will not be used.

Axxess ASWC-1 Specifications

General

Type	Steering Wheel Control Interface
Voltage	12V DC
Compatibility	Compatible with most aftermarket radios and vehicles with steering wheel controls
Vehicle Integration	Connects aftermarket radio to factory steering wheel controls
Programming	Auto-detects vehicle and radio, customizable button assignments
Firmware Updates	Updatable via USB
Data Retention	Retains settings even after battery disconnection
Function	Allows control of aftermarket radio functions from the steering wheel