3
REV. 8/25/2017 INSTXSVI-6523-NAV
INSTALLING THE XSVI-6523-NAV INITIALIZING THE XSVI-6523-NAV
With the key in the off position:
• Connect the XSVI-6523-NAV harness into the interface, and then to the harness in the
vehicle.
Note:
If using the ASWC-1, connect it after you initialize and test the XSVI-6523-NAV, with
the key in the off position.
Attention!
If the interface loses power for any reason, the following steps will need to be
performed again. Also, if installing an ASWC-1 connect it after you initialize and test the interface/
radio, with the key in the off position.
• Turn the key (or push-to-start button) to the ignition position and wait until the radio comes on.
Note:
If the radio does not come on within 60 seconds, turn the key to the off position,
disconnect the interface, check all connections, reconnect the interface, and then try again.
• Turn the key to the off position, and then to the accessory position. Test all functions of the
installation for proper operation, before reassembling the dash.
To Next Page
Loading...
