your local dealer or a specialised technician in order to repair the fixture.
Cleaning:
Clean the housing of the fixture frequently with a damp cloth, to remove dust and/or dirt.
WARNING: Always disconnect the fixture from your wall outlet or other power supply and let the fixture dry
before reconnecting it. This prevents possible electric shocks.
The lenses can be cleaned with a non-aggressive glass cleaning solution, but this is not recommended. Ayra
advises cleaning the mirror and lens with a fine brush, while removing dust and/or dirt with a vacuum cleaner.
Avoid touching the lenses with your bare fingers, to prevent fingerprints on the optics.
Check-up
To prevent dangerous situations, make sure your fixture is in optimal condition before using it. Check your
fixture frequently by using the following check list:
- All screws must be mounted tightly.
- Check all screws and metal parts for corrosion. No visible corrosion may be present.
- The exterior of your fixture must be in optimal condition. Check your fixture for dents, cracks or missing
parts.
- Your installation spot must be in optimal condition. Check your installation spot for corrosion, cracks, dents
and strength.
- Electrical components (connectors and cables) must be in optimal condition. No form of damage (cuts,
exposed wire cores or any other irregularities) should be visible.
If any visual or mechanical damage is detected, contact your local dealer or a specialised technician. Do not
use a damaged or failing fixture.
Connectors and wiring schematics:
DMX connectors: Electrical wiring:
Any information and illustrations shown in this user manual are subject to change without further notice.
User manual version: 1.0 Creation date + author initials: 22-04-2015 RV Revision date + author initials: -
To Next Page
Loading...
