Ayra ComPar KIT 3 - Technical Specifications; General System Specifications; LED Source and Projector Features; Connectors and Included Accessories

Technical specifications
- compact light system
- equipped with four projectors
- projectors individually adjustable
- amazing colour mixing thanks to COB RGB LED light source
- removable lens, change the dispersion angle from 30 to 120 degrees!
- automatic, sound-activated, master-slave and DMX operating modes
- compatible with Compar Kit 1 and 2
- two selectable ‘Slave’ modes
- microphone sensitivity digitally adjustable for sound-activated mode
- several DMX channel modes (1, 3, 7, 12 or 16 channels)
- LED display with menu buttons
- display invert
- IEC C14 power inlet
- tightening knobs at the top for extra projectors
- integrated stand adapter with tightening knob
- included foot controller, for easy light show control by musicians and DJs
- included light stand, for easy plug-and-play setups
- included transport bag for the system + light stand for optimal safety and convenience during
transport and storage
- power requirements: 110 - 230 V AC, 50/60 Hz
- power consumption: 170 VA
- two power outputs, suitable for powering other ComPar kits, ComPar fixtures or (LED) light fixtures
- ComPar Kit fuse: F3A, 20mm glass
- power outputs fuse: F7A, 20mm glass
- total weight: 10.5 kg
LED light source:
- for each spotlight: 30W COB RGB LED chip with reflector
Projector features:
- four separate projectors on each system
- equipped with heat sinks for optimal cooling and long lifespan
- wide-angle manual pan and tilt for each projector individually, for optimal beam adjustment
- solid cable from every projector to the main bar
- amazing colour mixing thanks to COB LED technology
- removable lens to adjust the light dispersion for any purpose
- included and easy-to-mount uplighting feet, for wall washing and uplighting purposes
Connectors:
- DMX: 3p XLR male and female
- power in: IEC C14 male chassis
- power out: IEC C13 female chassis
- foot controller: 5p Aviation
Included accessories:
1x light stand
1x foot controller with connection cable
1x padded case for ComPar Kit 3
1x light stand bag
1x power cable IEC C13 to Schuko (3x 1mm²)
1x power cable IEC C13 to UK plug (3x 1mm²)
2x uplighting feet
6x tightening knob (2 for stand adapter, 4 for top mounting)
Technical details:
Any information and illustrations shown in this user manual are subject to change without further notice.
User manual version: 1.0 Creation date + author initials: 22-04-2015 RV Revision date + author initials: -