What to do if Azbil Transmitter meter does not indicate or output?
If your Azbil Transmitter meter isn't showing any indication or output, verify that the power supply voltage is correct and that the wiring for both the power and the meter are properly connected.
Why does the indication or output of my Azbil ALTJ 9000 meter deviate?
If the indication or output of your Azbil Transmitter meter is off, ensure that you've correctly performed the Zero Adjustment and Adjustment of Meter Pointer Position. Also, check that the rear cap on the junction box's rear panel isn't blocked by sludge or sand, and confirm that the probe isn't excessively tilted.
How to fix the fluctuating indication or output on Azbil ALTJ 9000 Transmitter?
If the indication or output of your Azbil Transmitter meter is fluctuating, you should check whether the damping setting is appropriate.
General| Model | ALTJ 9000 Series |
|---|---|
| Category | Transmitter |
| Accuracy | ±0.1% of span |
| Ambient Temperature Limits | -40 to 85 °C (-40 to 185 °F) |
| Communication Protocol | HART |
| Housing Material | Stainless Steel |
| Output Signal | 4-20 mA, HART |
| Process Temperature Limits | -40 to 120 °C (-40 to 248 °F) |
| Power Supply | 10.5 to 42 V DC |
| Protection Degree | IP67 |
To Next Page
