9-7
Chapter 9 Maintenance and Inspection
Disassembling the Junction Box
Before disassembling the junction box, be sure to turn off the power.
y
Disconnecting the Hollow Cable
(1) Loosen the four screws of the junction box cover to remove the cover.
Fig. 9-9. Removing the cover
(2) Remove the lower two screws of the four screws that hold the plate (terminal block
assembly) at the center of the junction box. Be careful not to drop the screws when
removing them.
plate
Fig. 9-10. Removing the terminal block assembly (the lower two screws)
Screw (4)
To Next Page
Loading...