9-8
Chapter 9 Maintenance and Inspection
(3) Loosen the remaining upper two screws that hold the terminal block assembly and
remove the terminal block assembly by sliding the plate. Do not pull hard on the
hollow cable since it is connected to the terminal block section on the rear panel of the
plate. Excessive pulling may break the wires.
Fig. 9-11. Removing the terminal block assembly
(4) Disconnect the wires from the RED (+), BLK (-), and GND terminals of the terminal
block on the rear panel of the plate.
Fig. 9-12. Disconnecting the hollow cable terminals
Slide.
GND BLK (-) RED (+)
To Next Page
Loading...