Azbil Corporation
Model: AMT, HDT - CV3000 Series Control Valves
7
Fig. 2-2 Lubricator(Class 600 or under)
Lubricating Procedure
(a) prepare grease of the type indicated on the nameplate.
(b) Tightly close the lubricator handwheel.
(c) Remove the squeeze screw, apply grease, and set the squeeze screw.
(d) Loosen the lubricator handwheel and drive grease by turning the squeeze screw.
(e) Repeat the procedure of (b), (c) and (d) until turning of the squeeze screw
becomes heavier. Tightly close lubricator handwheel.
(5) When raising temperature of a valve which is used for high temperature service,
raise temperature gradually (standard rate is 100
per hour) and do not operate
the valve when its temperature is being raised.
To Next Page
Loading...
