Azbil Corporation
Model: AMT, HDT - CV3000 Series Control Valves
49
8.3 Disassembly of Side Assembly of Side Handwheel
Before starting disassembly, check that the pointer is set at the AUTO position.
(Refer to Fig. 8-1)
(1) Loosen the bolt 6 which connects the levers 2 and then disengage the levers
from the pointer.
(2) Undo the mounting-bolts 1 of the side handwheel unit and detach it from the
actuator.
(3) Remove the lock nut of the handwheel and then remove the handwheel.
(4) Loosen the bolt 8 of the bearing holder and then remove the feed shaft 7.
To assemble the side handwheel, refer to Fig. 8-1 and follow the disassembly
procedure in the reverse order.
To Next Page
Loading...
