8
Chapter 2. Installation and Wiring
CAUTION
Turn the power off before mounting the device on the sub-base. Otherwise, device failure may
result.
Mounting the main unit on the sub-base (sold separately) and removing it
z
Mounting
(1) Align the indentation in the center of the top of the
device with the projection on the sub-base.
(2) Once aligned as in (1), slowly push the device toward
the sub-base.
(3) Tighten the device’s retaining screws to secure it in the
sub-base. (Maximum tightening torque: 0.5 N·m).
z
Removing
(1) Remove the mounting screws.
(2) Pull the device out toward you while holding down the
sub-base.
To Next Page
Loading...
