Need help?Do you have a question about the Azbil MagneW 3000 and is the answer not in the manual?
General| Brand | Azbil |
|---|---|
| Model | MagneW 3000 |
| Category | Measuring Instruments |
| Language | English |
Mounting the converter using M4 screws and handling the rubber bush for isolation.
Installing the detector in the environment, connecting cables, and ensuring proper pipe alignment.
Details on connecting converter wiring, pulse output wiring, and master-slave wiring.
Selecting an appropriate range for the flowmeter, aiming for approximately 70% flow rate.
Choosing between 0.1 mL/P or 0.05 mL/P pulse scales for flow measurement.
Selecting pulse width options of 30 µS or 200 µS and their tolerances.
Setting the dropout value (0-10%) to prevent incorrect totalization due to flow pulsation.
Configuring converters in master/slave mode to minimize magnetic interference in multi-head applications.
Ensuring 30-minute warm-up for electronics stabilization and removing bubbles for accurate measurement.
Performing zero adjustment using a variable resistor or PLS ZERO button for flow rate accuracy.
Tuning the span using the 'SPAN' variable resistor to correct discrepancies between actual and measured values.
To Next Page
