Azbil AUR355 - Communication Setting Mode

19
Chapter 3. Operating This Device

Communication setting mode
Transition to communication setting mode
Communication setting
(1)
(2)
(3)
(2)
(1) Press and hold the DISP switch for approximately 5 s or more
during the stop status (when the start switch is OFF). The
7-segment display changes to C 1 and the system goes into
communication setting mode. The central dot of the 7-segment
display starts blinking. (a 1 s cycle)
(2) When the DISP switch is pressed, the display changes in the
following order: → H 1 → H2 → H3 → CL�
Select a communication setting type using the DISP switch.
Display Description
H 1
Communication address setting
H2
Baud rate setting
H3
Communications format setting
CL
Initialization of settings
Note
• For the 200 or 220 V AC model, you can set H 1, H2, and H3
even if the power is 100 V AC.
z
Selection of communication setting mode
z When a selection from H1 to CL is made
• Communication address setting (H 1)
Use the DISP switch to select H 1 on the 7-segment display.
1. Press the RESET switch. The 7-segment display shows
H 1/_. _ is the address value. (Default setting: 1)
2. When the DISP switch is pressed in this situation, the display
cycles through → H 1/ 1 → H 1/2 → H 1/3……H 1/32.
Select the address.
3. After making a selection, press the RESET switch.
“H 1”blinks, and when the blinking ends, configuration is
complete.
At this time,H 1is displayed.
• Baud rate setting (H2)
Use the DISP switch to selectH2on the 7-segment display.
1. Press the RESET switch. The 7-segment display shows
H2/_. _ represents 1, 2, or 3. (Default setting: 3)
1 : 4800bps
2 : 9600bps
3 : 19200bps
2. When the DISP switch is pressed in this situation, the display
cycles through → H2/ 1 → H2/2 → H2/3.
Select the baud rate.