Azbil AUR355 - Mounting in a Panel; Mounting on a DIN Rail

7
Chapter 2. Installation and Wiring

Mounting on a DIN Rail
(1) Pull down the sub-base’s DIN rail clamps.
(2) Attach the sub-base to the DIN rail, making sure that the sub-base is not
upside-down.
(3) Push up the DIN rail clamps to fasten the sub-base to the DIN rail.
Pull down
the DIN rail clamps
Push the DIN rail clamps
upwards to x in place
Attach sub-base to DIN rail

Mounting in a panel
(1) Cut two M4 threaded holes in the panel.
Unit:mm
62.5
M4
(2 locations)
(2) Use screws to mount the sub-base in the panel.
(Maximum tightening torque: 1.2 N·m)