AB-6256
2
Safety Instructions
Please read instructions carefully and use the product as specified in this manual. Be sure to keep this manual near by for ready
reference.
Usage Restrictions
This product is targeted for general air conditioning. Do not use this product in a situation where human life may be affected. If
this product is used in a clean room or a place where reliability or control accuracy is particularly required, please contact
zbil
Corporation’s sales representative. Azbil Corporation will not bear any responsibility for the results produced by the operators.
WARNING
• Do not disassemble the product. Disassembly may result in electrical shock or equipment damage.
CAUTION
• Installation and wiring must be performed by qualified personnel in accordance with all applicable safety
standards.
• This product must be operated under the operating conditions (power, temperature, humidity, vibration, shock,
installation position, atmospheric condition, etc) specified in this manual to prevent equipment damages.
• This product must be operated within its rated operating ranges specified in this manual. Failure to comply will
cause equipment damage.
• All wiring must comply with local codes of indoor wiring and electric installation rules.
• This product does not have a power switch. Install the power circuit breaker in the power source.
• Always disconnect power source before performing any wiring.
• Use crimp terminal lugs with insulation for electric wires to be connected to the screw terminals.
• Make sure all the wires are tightly connected to the screw terminals. Loose connection may cause fire or heat
generation. Loose connection also may lower the measuring accuracy.
• Dispose of this product in accordance with your local regulations. Do not reuse all or part of this product.
Trademark information:
Bayblend and Makrolon are registered trademarks of Bayer MaterialScience AG.
IMPORTANT:
Regarding the operating conditions, in a space where fresh air is always required or more fresh air than usual
is required due to hard work intensity, it is dangerous to control fresh air (outdoor air) intake. Do not control
fresh air (outdoor air) intake using CO
2
measuring instruments including this product under such conditions.
To Next Page
Loading...
Need help?
General
