Azbil Infilex GC WY5111 - Page 8

AB-6528
8
Mounting Dimensions
DIN rail mounting
Fig. 6 shows the mounting dimensions of Infilex GC on the DIN rail.
Mount and fix Infilex GC on DIN rail so that it does not fall from the DIN rail. Check that the DIN rail holders of each module are
pushed up and fixed on the DIN rail.
Fasten the bilateral sides of Infilex GC with two DIN rail mounting brackets (Part No. 83104567-001, separate order is required).
Notes:
1 Pitch between upper/lower duct and DIN rail.
2 Hatched area shows the maintenance space.
3 ‘n’ indicates the number of I/O module, UT module, integral type Operator Panel, and/or SAnet I/F module assembled with Infilex GC basic
unit.
4 DIN rail position is shifted 5 mm downward from the center of Infilex GC.
The width of Infilex GC may vary depending on the number of an I/O module, UT module,
integral type Operator Panel, and/or SAnet I/F module to be assembled. Their outside
dimensions are the same.
Width of Infilex GC = One module (30 mm)  n (quantity) + Infilex GC basic unit (60 mm)
Notes:
 Panel mount type Operator Panel is not directly assembled with Infilex GC. To connect it to
Infilex GC, a UT module is required.
For details of panel mount type Operator Panel, please refer to Specifications/Instructions of
Operator Panel (AB-6546).
 For details of I/O modules, UT module, integral type Operator Panel, and SAnet I/F module that
can be assembled with Infilex GC, refer to Specifications/Instructions of Model RY50XX
(AB-6527).
I/O module (mm)
Figure 6. Mounting dimensions: DIN rail mounting (mm)
30
DIN rail mounting brackets for bilateral sides
Part No. 83104567-001
Duct
Duct
Infilex GC
(
45
)
35
140
(45)
(122.5)*
1
(132.5)*
1
Duct
20
50
92
(60)
(60)
Duct
65 75
35

2
DIN rail holder
Infilex GC
basic unit
DIN rail
Infilex GC
60 + 30  n*
3
Hook
I/O modules, UT
module, integral type
Operator Panel,
SAnet I/F module
5*
4
106