When shipping out the device to you, it has already pre-installed latest firmware. So
by default you don’t need to install that.
Go to the directory where you downloaded the software, then double
click on Azeron-setup-vX.XX.X to install the software.
Sometimes Windows may prevent installation, because it is a new
software it doesn’t recognize:
Just click on the “More info” and then on “Run anyway”.
After that, the software will start to install. When it’s done, there will be
a shortcut icon on Desktop and in the Start menu.
In case the software installation stops midway and doesn’t progress,
make sure to pause your antivirus and try to install again.
After the installation is done, plug in the USB cable of the device in PC
and then launch the Azeron software.
If you are not sure if your PC has the USB3.0 motherboard drivers installed, then we
would suggest to use USB 2.0 port to avoid unpredictable behavior of the keypad
recognition.
Also if you are using USB hub, the keypad may flicker and have power loss. So make
sure to use USB hub that can provide enough power or plug in the keypad directly in
PC motherboard
To Next Page
Loading...