Aztech HL117 E

User Manual
Page 19 of 43
Step 2
Press Simple Connect
for 5
-
8
seconds from a HomePlug AV Z.
A
fter you release the button, Power
LED and Ethernet LED (Ethernet is connected) will turn off and turn on.
Note: If the Power and Ethernet LED did not turn off and on, press Simple Connect again for 5-8
seconds.
Step 3
Press Simple Connect Button
for
two seconds on the existing HomePlug AV device. A
fter you release
the button, the Power LED will continuously blink. If the Power LED did not blink, press
Simple Connect again for two seconds.
Make sure to press Simple Connect Button again on the HomePlug AV Z within two minutes after
you press Simple Connect from the existing network.