Figure 4
The detector should be switched type (always on or always off). If the detector has detected
the smoke or people or animal to enter the area, the detector will switch on or switch off. And
it will send the external alarm signal into the IP camera.
4 Network Connection
Figure 5
IP Camera can be connected with other PC through router, switch or hub to establish a
network. Figure 5 shown connections.
4.1 Connection Instruction
Before visiting the IP Camera, you should firstly connect it to the Network, supply the power
to it, and check if the light of RJ45 Socket is normal to make sure all of the communication
links are fluency. The connection method likes as Figure 5.
1) IP Camera-1 and IP Camera-2 are connected separately to 2 different LANs.
2) And these 2 LANs are already connected to the Internet. In order to get the LANs to be
connected to the Internet, they are required to be equipped with router and to apply for
the communication link from the local Internet Service Provider (ISP) and connect to it by
ADSL or optical fiber, etc.
PIR
PIR Power
Input
pins
Switch
To Next Page
Loading...
