ULT FREEZER – USER MANUEL
Updated 19. April 2021
Step 5
Use pin code 0000 to enter the USER menu
and press OK.
Step 6
Press on the UPDATE DATA button to enter the next menu.
Step 7
In this UPDATE MENU, you can see new detected firmware
which are in green color.
Press the FIRMWARE RESOURCES button to update firmware.
When the controller is finished updating firmware,
the controller will perform a rebooting.
Step 8
For uploading new parameter file,
you need to go from Step 3 to step 6 again
In this UPDATE MENU, you can see new detected parameters
which are in green color.
Press the PARAMETERS button to upload the new parameter.
PS. If the Controller does not detect any new files,
please check that you have copied the files into the correct
folder in the USB stick.
To Next Page
Loading...
General