Baby Lock PRESTO User Manual

Replacing the Presser Foot
B-28
Replacing the presser foot
a
Press (Needle position button) once or twice to
raise the needle.
b
Turn off the machine.
c
Raise the presser foot lever, if necessary.
d
Press the black button at the back of the presser foot
holder.
1 Black button
2 Presser foot holder
e
Place a different presser foot below the holder so that
the presser foot pin is aligned with the notch in the
holder.
1 Presser foot holder
2 Notch
3 Pin
4 Presser foot type
f
Slowly lower the presser foot lever so that the presser
foot pin snaps into the notch in the presser foot holder.
1 Presser foot lever
2 Presser foot holder
3 Notch
4 Pin
→ The presser foot is attached.
g
Raise the presser foot lever to check that the presser
foot is securely attached.
1 Presser foot lever
Replacing the Presser Foot
CAUTION
• Use the presser foot appropriate for the type
of stitch that you wish to sew, otherwise the
needle may hit the presser foot, causing the
needle to bend or break.
• Only use presser feet designed specifically for
this machine. Use of any other presser foot
may result in injuries or damage to the
machine.
CAUTION
• Before replacing the presser foot, be sure to
turn off the machine, otherwise injuries may
occur if the “Start/Stop” button or any other
button is pressed and the machine starts
operating.
a
b
1
2
3
4
J
2
3
4
1
1

Baby Lock PRESTO Specifications

General

Buttonhole Styles	7
Stitch Width	7mm
Stitch Length	5mm
Bobbin Type	Drop-in
Screen	LCD
Lighting	LED
Type	Computerized
Stitch Length Control	Yes
Stitch Width Control	Yes
Free Arm	Yes
Speed Control	Yes
Start/Stop Button	Yes
Needle Up/Down	Yes
Reverse	Yes
Speed	850 stitches per minute
Presser Feet	7