Basic Stitching
S-6
Straight stitches are used for sewing plain seams.
* Stitch patterns can be selected directly by pressing the
numeric keys on the machine during preset utility stitch
mode. Refer to “Basic operations” section.
Basting
Sew basting with the preset stitch length of 5 mm (3/16 inch).
a
Attach zigzag foot “J”.
b
Select stitch
.
c
Start sewing.
Basic stitching
a
Baste or pin together the fabric pieces.
b
Attach zigzag foot “J”.
c
Select a stitch.
d
Lower the needle into the fabric at the beginning of the
stitching.
e
Lower the presser foot lever, and then start sewing.
f
When sewing is finished, cut the thread.
Chapter 2
UTILITY STITCHES
Basic Stitching
Stitch name Stitch
Presser foot
Stitch number
Basting stitch 07
J
Straight stitch (Left)
01
*
02*
Straight stitch (Middle)
03
*
Straight stitch (Middle)
04*
Triple stretch stitch
05
*
• If the basting threads fall out of the fabric, pull up
the bobbin thread before sewing, and then pull
the upper thread and bobbin thread under the
presser foot toward the back of the machine (refer
to “Pulling up the bobbin thread” in the “Basic
operations” section). Hold the upper thread and
bobbin thread when beginning to sew, and when
finished sewing, cut the threads leaving an excess
amount of thread.
Finally, hold the upper thread and bobbin thread
at the beginning of the stitching while arranging
the fabric.
J
To Next Page
Loading...
Need help?
General
