W W W . B A L T I M O R E A I R C O I L . C O M . A U
14
M A R 2 0 8 - 0
PLATFORM INSTALLATION
Factory Fitted Platforms
Where a platform is supplied with the unit it is normally tted to the casing
section at the factory. In this case only the ladder, stiles and landing need
to be tted on site. See gure 11a below demonstrating this.
Pre-Assembled Platforms Shipped Loose
In some instances due to transport limitations it is necessary to ship the
platform separate from the unit. In this case the platform must rst be
lifted up and xed to the platform support beam. See gure 11b below
demonstrating this. Once the platform is tted to the support beam the
ladder, stiles and landing can be tted as above.
Figure 11a.
Figure 11b.
To Next Page
Loading...