W W W . B A L T I M O R E A I R C O I L . C O M . A U
16
M A R 2 0 8 - 0
4
RC SERIES
Final Assembly Details
Inspection
Prior to start-up, the following services, which are described in detail in
the RCC/RCF Operating and Maintenance Manual, must be performed:
- Inspect general condition of unit.
- Inspect fans, motors, bearings, drives, and belts for condition and
alignment.
- Lubricate all bearings and purge them of old grease.
- Check fans and air inlet areas for obstructions.
- Clean and ush basin, depressed sump and strainer.
- Inspect spray nozzles and heat transfer section.
- Check make-up valve and basin water level.
- Proper start up procedures and scheduled periodic maintenance
will prolong the life of the equipment and ensure the trouble-free
performance for which the unit is designed.
Piping (Process Water/Refrigerant)
All piping must be supported external to the tower and restraint
provided to ensure no vertical or horizontal movement of the piping. All
piping and supports are to be furnished by others.
Fan Speed
When the fan speed of this product is to be changed from the factory
set speed, including the use of a variable fan speed control device,
steps must be taken to avoid operating at or near the fan’s “critical
speed” which could result in fan failure and possible injury or damage.
Freeze Protection
This product must be protected by mechanical and operational
methods against damage and/or reduced effectiveness due to
possible freeze up. Please contact the local BAC Representative for
recommended protection alternatives.
WARNING: Do not run pump
unless basin is lled with water
To Next Page
Loading...
Need help?
General