MGS Series Controller Manual
6709-9000 Rev 1 7
Figure 2. Sample Configurations (4,6-Channel)
MGS Controllers have either one or two relay outputs: one for single-
level alarm controllers (“Alarm”), and 2 for dual-level alarm controllers
(“Alarm High” and “Alarm Low”). Unlike the alarm LEDs that provide a
channel-by-channel alarm status of each incoming transmitter’s signal,
the relay output “trips” or “energizes” if any of the inputs exceed the
alarm threshold set by the pot (that is, if any of the alarm LEDs is
energized). Alarm relays can be used to activate warning lights, sirens,
ventilation fans, etc.
To Next Page
Loading...
