Dynamis User Guide
Edit track timeout
The Dynamis Handset and Command Station stay in contact. If the line of sight is lost
the Command Station cuts track power. Use this setting to adjust the length of time
before power is cut when contact is lost.
Edit Service Track Programing
Selects the modes used for Service Track programming.
Select a combination of the programming methods according to the requirements of
the decoder being programmed.
Direct ‘CV’
Paged mode ’PM’
Register mode ’RM’
With or without programming track power down.
èMost decoders will accept Direct Mode - leave at this setting unless a decoder has
another requirement. Please consult you decoder instructions. More programming
methods in use at one time increase the time to program.
Factory reset
Restores the default values, deleting all locomotives that are stored in the roster
database.
Edit base ID
4 infra-red channels are available so that different layout in proximity can be
controlled. The Command Station jumper and the handset to must operate on the
same channel. Leave at 0 unless two or more Dynamis systems are being used in
close proximity.
Edit base name
Allocates a name to the Command Station - used with the ProBox only
Edit remote name
Set a name for the Handset.
How to make the best of Dynamis on your layout
What kind of turnouts should be used?
Either ‘live’ or ‘dead’ frog turnouts can be used with Dynamis, to the layout builder’s
choice – dead frog turnouts are easier to install as the live frog turnout usually
requires extra wiring. Details of the requirements included with the particular
products.
To Next Page
Loading...
Need help?
General
