Dynamis User Guide
Use only for the control of model trains.
Wipe only with a damp cloth - do not immerse in water or use any other cleaning
agents.
For indoor use only - don’t allow to become wet.
The handset is a precision item and should be treated with care - always use the
lanyard to avoid dropping.
Batteries Use AAA / MN2400 / LR03 batteries
Alkaline or NiCad or NiMH rechargeable batteries are suitable
Insert into the handset with correct polarity
Follow guidelines on the use and disposal of batteries
Remove batteries from the handset when not in use to avoid
damage from leakage
Fault finding
I can’t run a train with my Dynamis system
Power supply not connected to Command Station - LEDs will illuminate on
Command Station when power is applied. Connect power.
No connection to track - check connections.
Battery low indicator on Handset - replace batteries.
STOP or Short circuit indicator on Handset - check cause and press STOP to reset
unit.
Handset out of range of Command Station- STOP will be illuminated - press to
reset. The LED on the Command Station receiver flashed when signals are received.
Incorrect address of loco selected - check loco address and select locomotive with
correct address.
Handset and Command Station not on same channels - check setting of Handset and
set Command Station jumpers to the same channel.
To Next Page
Loading...
Need help?
General
