What to do if Badger Meter 220 sensor fails to respond?
If the Badger Meter Accessories sensor does not respond even after manually spinning the impeller, the suggested solution is to replace the sensor.
Why is the voltage at Badger Meter 220 Accessories sensor input less than 7V DC?
If the voltage at the Badger Meter Accessories sensor input is less than 7V DC in a no flow situation, disconnect the sensor from the barrier strip and measure the voltage again at the sensor input terminals of the barrier strip. It should be between 8…20V DC. If the voltage at the sensor input is still below 7V DC or 3V DC, the problem may be with the monitor (hardware or programming).
General| Brand | Badger Meter |
|---|---|
| Model | 220 Series |
| Category | Accessories |
| Language | English |
Step-by-step guide for sensor installation.
Critical steps for sensor depth and alignment.
Installation steps for drained pipes.
Installation steps for pressurized pipelines.
Electrical connections for standard sensor models.
Electrical connections for IR sensor models.
Electrical connections for high temperature sensors.
Explanation of data columns in calibration tables.
To Next Page