Baehr TEC A2000 - Page 27

BaehrTec A2000 operating instructions
English – V101 - effective 10/13
Page 27/58
Here, ready for operation does not necessarily mean that the suction is actually active, as
the suction only becomes active when the suction is ready for operation and the
handpiece motor is also
in operation.
If the suction is actually active, this will be indicated on the display by two additional
symbols.
This symbol is displayed if the suction is not currently in operation with
the suction level you have set (suction off).
This symbol is displayed if the suction is currently in operation with
the suction level you have set (suction on).
(Can only appear while the handpiece motor is running).
Therefore, the following situations are possible:
Handpiece motor
Suction ready
for operation
Bar graph on the
display
Suction
Off
No
Transparent
Off
Off
Yes
Filled blue
Off
On
No
Transparent
Off
On
Yes
Filled blue
On
This offers you the following advantage:
If you set the suction so that it is “not ready for operation”, you can
see at all times which suction level you last selected. If you then
want to set the suction in the same way, all you need to do is simply
press button (20) and the suction will be ready for operation again.
As soon as you press one of the suction level buttons (21) – (26), (27) or
(28), this suction level will immediately be set and will also immediately be
“ready for operation”. This means you only ever have to press one
button.