Baehr TEC A2000 - Troubleshooting Common Issues

BaehrTec A2000 operating instructions
Page 46/58
English – V101 - effective 10/13
5.5 Self-help in the event of malfunctions
Fault
Cause
Solution
Controller
not
functioning
 Main switch off
 Controller not connected to
the mains
 Connection socket has no
power
 Power cable not correctly
contacted (plugged in)
 Fuse(s) not working
(see 5.5.1 Changing fuses)

Turn on main switch

Connect the device to the
mains
 Connect the device to a
functional socket

Plug device connector
correctly into the device
socket
 Check main fus
es and
replace if necessary
Before checking the fuses,
it is essential that the
device is
turned off and
disconnected
from the
mains.
Filter indicator
is lit up.
 Handpiece is blocked
 Dust bag is full
 Turbine protection filter in
suction box is blocked
 Filter cassette is blocked
 Unscrew front panel and
clean the handpiece.
It is essential that the device is
turned off and disconnected
from the mains beforehand!
 Change dust bag
 Change turbine protection
filter
 Change filter in cassette
Low suction
power and
the device gets
hot
 Filter check ignored
 Handpiece is blocked
 Dust bag is full
 Turbine protection filter in
suction box is blocked
 Filter cassette is blocked
 Exhaust is blocked
 Dust bag lid is not properly
closed
Seal has sli
pped from the duct
on the controller or the
handpiece outlet has become
dirty or is defective
 Regularly check for the
filter check display
 Unscrew the front panel
and clean the handpiece.
It is essential that the device is
turned off and disconnected
from the mains beforehand!
 Change dust bag
 Change turbine protection
filter
 Change filter in cassette
 Please ensure that the
extracted air can escape
easily from the back of the
device
 Properly close
the dust bag lid
 Check seals and replace if
necessary. Clean the filter
box, seal groove and dust
bag lid.