15
BF-UM-C-DP C244-EN July 2022
USER MANUAL FOR DISPLAY
Error Declaration Troubleshooting
37 WDT circuit is faulty
Using the BESST tool update the controller to see if
this resolves the problem. If not, please change the
controller or contact your supplier.
41
Total voltage from the battery is
too high
Please change the battery.
42
Total voltage from the battery is
too low
Please Charge the battery. If the problem still occurs,
please change the battery.
43
Total power from the battery
cells is too high
Please change the battery.
44
Voltage of the single cell is too
high
Please change the battery.
45
Temperature from the battery is
too high
Please let the pedelec cool down.
If problem still occurs, please change the battery.
46
The temperature of the battery
is too low
Please bring the battery to room temperature. If the
problem still occurs, please change the battery.
47 SOC of the battery is too high Please change the battery.
48 SOC of the battery is too low Please change the battery.
61 Switching detection defect
1. Check the gear shifter is not jammed.
2. Please change the gear shifter.
62
Electronic derailleur cannot
release.
Please change the derailleur.
71 Electronic lock is jammed
1. Using the BESST tool update the Display to see if it
resolves the problem.
2. Change the display if the problem still occurs,
please change the electronic lock.
81 Bluetooth module has an error
Using the BESST tool, re-update the software onto
the display to see if it resolves the problem.
If not, Please change the display.
To Next Page
Loading...
Need help?
General
