37
THE WATER SYSTEM
It should be noted that as the container volume
is likely to be less than that of the on-board
tank, it is advisable to remain in attendance
when filling the tank as the life of the pump will
be drastically reduced if allowed to run dry. To
fill an onboard tank to the brim you normally
have to repeat this procedure several times.
Should the motorhome be left unattended, or
the water supply has run dry, switch off the
power supply to the pump via the control panel
to avoid continuous running.
manual tank fIllIng
The tank can be filled manually using a
standard hose inserted directly into the tank.
The fresh water tank can be accessed via the
hatch in the floor of your motorhome.
1. Remove the hatch cover.
2. Unscrew the tank filler cap.
3. Insert hose and turn on tap.
4. Monitor the level of the tank via the
control panel or visually within the tank.
5. Turn off and remove hose.
6. Replace tank cap.
7. Replace hatch cover.
To Next Page
Loading...
