Bailey ADVANCE 2019 - Settings

91
THE SEATTLE CONTROL PANEL
SettingS
Contrast:
Adjusts the contrast of the LCD display if you
are finding it difficult to read.
Sound:
Enables or disables the sound when a button
is pressed.
Chg V Batt:
When enabled the vehicle battery will be
charged while 230V mains is connected. The
leisure battery will also be charged at the same
time.
Standby:
Sets how long the control panel waits for a
button press before going into standby.
Water Low:
Enables or disables the warning alarm when
the water tank is low;
> Press ENTER to acknowledge an alarm that
has triggered. The warning will only re-arm
when the water level increases by 25%.
Waste High:
Enables or disables the warning alarm when
the waste tank is high;
> Press ENTER to acknowledge an alarm that
has triggered; the warning will only re-arm
when the waste level is reduced to 50%.
230V Lost:
Enables or disables the warning alarm when
the 230V mains connection is lost;
> Press ENTER to acknowledge an alarm that
has triggered; the warning will only re-arm
when the 230V connection is restored.
Amps High:
Enables or disables the warning alarm when
the current drawn from the leisure battery
exceeds 12A;
> Press ENTER to acknowledge an alarm that
has triggered; the warning will only re-arm
when the current is reduced below 5A.
Veh Batt Low:
Enables or disables the warning alarm when
the vehicle battery voltage is less than 11V;
> Press ENTER to acknowledge an alarm that
has triggered; the warning will only re-arm
when the vehicle battery is charged over
13V.
Leis Batt Low:
Enables or disables the warning alarm when
the leisure battery voltage is less than 11V;
> Press ENTER to acknowledge an alarm that
has triggered; the warning will only re-arm
when the leisure battery is charged over
13V.
Auto Battery:
When enabled the power source will switch
to vehicle battery automatically if the leisure
battery is low. When a charging voltage is
detected, the power source will switch back to
leisure battery.
Shut down now:
Pressing ENTER will shut the control panel
down into its low power mode. The master
switch will be turned off and the clock will lose
its time.
> Press any button to turn the panel back on.
Firmware:
Displays the current firmware version installed
on the control panel.
Exit to Main Menu:
Saves any changes to the settings and
navigates back to the main menu.