vi WBPEEUI240756A0
Safety Summary
®
GENERAL
WARNINGS
Equipment Environment
All components, whether in transportation, operation or storage,
must be in a noncorrosive environment.
Electrical Shock Hazard During Maintenance
Disconnect power or take precautions to insure that contact with
energized parts is avoided when servicing.
SPECIFIC
WARNINGS
Disconnect power before installing dipshunts on the module mount-
ing unit backplane. Failure to do so will result in contact with cabinet
areas that could cause severe or fatal shock. (p. 3-6)
There are exposed AC and DC connections inside the cabinet.
These exposed electrical connections present a shock hazard that
can cause injury or death. (p. 6-2)
If input or output circuits are a shock hazard after disconnecting sys-
tem power at the power entry panel, then the door of the cabinet
containing these externally powered circuits must be marked with a
warning stating that multiple power sources exist. (p. 6-2)
Never clean electrical parts of components with live power present.
Doing so exposes you to an electrical shock hazard. (p. 6-3)
Wear eye protection whenever working with cleaning solvents.
When removing solvents from printed circuit boards using com-
pressed air, injury to the eyes could result from splashing solvent as
it is removed from the printed circuit board. (p. 6-3)
To Next Page
Loading...
