Bajaj pulsar F250 - Page 41

37
Sr. NO.
Activities/Check Points
Recommended frequency - Service interval & Kms
29500~
24500~
19500~
14500~
9500~
4500~ 500~
7th
6th
5th
4th
3rd
2nd1st
750 5000 10000 15000 20000 25000 30000
33
General lubrication – Clutch lever /
Rear brake pedal
34
Tyre air pressure.
35
Mirror position & joint rmness.
All fasteners tightness, few are
1. Front & rear axle
2. Swing arm axle
3. Engine foundation
4.Rider / Pillion foot rest holder
(Stay)
36
37
Mobile USB port
38
Drain hole no blockage verication
below starter motor
39
Fuel tank water drain no blockage
verication
Use recommnded AP grease.
Front - 1.75 Kgf/cm2 (25PSI)
Rear (Solo)- 2 Kgf / cm2(28PSI)
Rear (Pillon)-2.25Kgf/cm2 (32 PSI)
Recommended Torque Values
Front & Near axle:8 to 10Kgf-m
Swing arm axle-13 to 15 Kgf-m
Engine foundation-
Front top : 2.8 to 3 Kgf-m
Front bottom : 4 to 4.2 Kgf-m
Rear : 4 to 4.2Kgf-m
Rider/Pillon foot reast holder - 1.8
to 2.2 Kgf-m
Charging OK to be Checked at Engine
start condition using LED USB light
C,L C,L C,L C,L C,L C,L C,L
C,A
C,A
C,A
C,A C,A C,A C,A
C,A
C,A
C,A C,A
C,A
C,A
C,A
C,T
C,T C,T C,T
C,T
C,T C,T
C,R C,R C,R C,R
C,R
C,R
C,R
C,CL
C,CL
C,CL
C,CL
C,CL
C,CL
C,CL
C,CL
C,CL
C,CL
C,CL
C,CL
Remarks