Balboa TP200 - Miscellaneous Panel Messages; Control System Related Messages

TP200 USER GUIDE 42369 Rev A2
34
33
Balboa Water Group | Your Single Source Solution
No Communications.
The panel is not receiving communication from the control system.
Contact your dealer or service organization.
°F or °C is replaced by °T.
The Control System is in Test Mode.
Contact your dealer or service organization.
Control System PanelNo Communications Panel Cable
*
* *
Memory Failure - Checksum Error. **
At Power-Up, the system has failed the Program Checksum
Test. This indicates a problem with the firmware (operation
program). Contact your dealer or service organization.
Message
Code *
Memory Warning - Persistent Memory Reset. **
Appears after any system setup change. Contact your dealer
or service organization if this message appears on more
than one power-up, or if it appears after the system has been
running normally for a period of time.
Message
Code *
Clock Error. **
The clock that keeps track of time when the spa is powered O
has failed. Contact your dealer or service organization.
Note: Not Applicable on some control systems.
Message
Code *
Configuration Error – Spa will not Start Up.
Contact your dealer or service organization.
View page 55 for instructions on how to review the Fault Log that corresponds with the Message Code.
This message can be reset from the panel with any button press.
PANEL MESSAGES
MISCELLANEOUS
PANEL MESSAGES
CONTROL SYSTEM RELATED