Need help?Do you have a question about the Balluff BTL7-A510 Series and is the answer not in the manual?
General| Series | BTL7-A510 |
|---|---|
| Category | Transducer |
| Protection Class | IP67 |
| Housing Material | Stainless steel |
| Output Signal | Analog voltage, Analog current |
| Supply Voltage | 10 to 30 VDC |
| Operating Temperature | -40 to +85 °C |
| Connection Type | Connector |
Defines signal words and structures for hazard warnings to ensure user safety.
Defines the permissible applications and environments for the sensor in explosive areas.
Outlines uses that are not approved or could lead to hazardous situations.
Details essential safety precautions for operating the device in hazardous environments.
Covers guidelines for the correct use, inspection, and maintenance of the sensor.
Classifies the device according to explosion protection zones and suitability for specific areas.
Highlights critical special conditions required for safe operation, marked with 'X'.
Instructs on the correct procedures for assembling, installing, and setting up the sensor.
Outlines requirements for maintenance, regular inspections, and authorized repair procedures.
Details installation guidelines for sensors used in areas outside of Zone 0.
Provides specific instructions for installing the sensor, including material considerations.
Details the pin assignments and wiring procedures for connecting the sensor.
Guides the initial power-up and startup sequence of the position sensor system.
Details the procedure for setting new null and end points for the sensor.
Explains how to adjust start and end values when the magnet position is critical.
Describes how to set start and end values while the system is running.
To Next Page
