Need help?Do you have a question about the Balluff BTL7 Series and is the answer not in the manual?
General| Measurement Principle | Magnetostrictive |
|---|---|
| Resolution | Up to 1 μm (depending on model) |
| Operating Temperature | -40°C to +85°C |
| Protection Class | IP67 |
| Housing Material | Aluminum |
| Output Signal | Analog |
| Supply Voltage | 10V to 30V DC |
Specifies the intended application and restrictions for the transducer.
Provides essential safety guidelines for installation and operation.
General advice for installing the transducer in different materials.
Details on transducer mounting, screw tightening, and support.
Information on connecting the transducer via cable or connector.
Critical steps for safely powering on and initiating the transducer system.
Steps to initiate the teach-in process.
Procedure to set the new null point.
Steps to initiate the adjustment process.
Procedure to set the new start point.
Procedure to set the new end point.
Steps to initiate the reset procedure.
Procedure to restore factory settings.
Specifications for transducer accuracy under various conditions.
To Next Page
