Need help?Do you have a question about the Balluff BTL7-E500-M0500-H-S32 and is the answer not in the manual?
General| Protection Class | IP67 |
|---|---|
| Type | Magnetostrictive |
| Measuring Range | 0 to 500 mm |
| Output Signal | Analog |
| Supply Voltage | 10 to 30 V DC |
| Resolution | 0.01 mm |
| Repeatability | ≤ 0.01 mm |
| Connection | M12 connector |
| Housing Material | Aluminum |
| Operating Temperature | -40...85 °C |
Provides essential safety precautions for installation, operation, and maintenance personnel.
Provides detailed steps and considerations for physically installing the transducer.
Details how to connect the transducer electrically via connectors or cables.
Pin assignment and wiring for the S32 connector type.
Pin assignment and wiring for the S115 connector type.
Explains wiring configurations for different cable types and color codes.
Covers essential EMC measures, grounding, and proper cable management.
Outlines the procedure for safely initiating the system after installation.
Details the step-by-step process for teaching in new null and end points.
Explains how to adjust start and end values and their effect on the output.
Describes the procedure for restoring the transducer to its factory default settings.
Provides detailed steps for performing the teach-in procedure, including activating inputs and setting points.
Details the process for adjusting operational parameters like start and end points.
Specific step to set the new end point of the measurement range.
How to modify the output value at the end point.
To Next Page