Bambu Lab X1 - First Print

Inse the lament into the PTFE Tube. Keep
pushing the lament until it can not move forward.
Apply a thin layer of glue on the build plate.
Press " " - "Temperatre/Axis" - "Extruder" - " "
about 5 times until the lament stas being pulled
by the extruder and cannot be pulled out manually.
*We recommend using the supplied Bambu PLA Basic
for your rst test print.
First Print
1
3 4
2
Press " " - "internal". Select a le to sta
the rst print.
*We recommend using one of the pre-loaded les as a
rst test print.