Need help?Do you have a question about the Bambu Lab A1 mini and is the answer not in the manual?
General| Build Volume | 180 x 180 x 180 mm |
|---|---|
| Nozzle Temperature | Up to 300 °C |
| Supported Filaments | PLA, PETG, TPU |
| Filament Diameter | 1.75 mm |
| Print Speed | up to 500 mm/s |
| Connectivity | Wi-Fi |
| Print Technology | FFF (Fused Filament Fabrication) |
| Layer Resolution | 0.3 mm |
| Nozzle Diameter | 0.4 mm |
Remove the four screws to unlock the Z-axis limiter during setup.
Cut the ziptie that is wrapped around the toolhead assembly.
Remove any foam padding material from the toolhead area.
Tighten the three screws circled in green to secure the heatbed.
Plug the AMS lite 4pin connector into the port on the right of the A1 mini.
Turn on the A1 mini using the power switch located on the back.
Get the Bambu Handy App, register, and log in to your Bambu Lab account.
Use the Bambu Handy App to scan the printer's QR code for binding.
Follow on-screen instructions to complete the printer's initial calibration.
To Next Page
