① The AMS lite suppos spools with a width of 40-68 mm and an inner diameter of 53-58 mm.
② Avoid using AMS lite to print exible materials, including TPU, TPE, or absorbent PVA.
Avoid using materials that are too hard (too high modulus) or too brittle (not enough
toughness), including third-pay ber reinforcement materials (PA-CF/GF, PET-CF/GF,
PLA-CF/GF, etc.). Please use external spool placement to print these lament.
40-68 mm
53-58 mm
*Warning
To Next Page
Loading...
