Why is auto close not working on my B&D PanelPro Door Opening System?
If auto close is not working on your B&D Door Opening System, the safety beam or wiring may be faulty. Repair the safety beam or replace the wiring and re-align the optics. See the safety beam instructions for further guidance.
How to fix the courtesy light on my B&D PanelPro?
If the courtesy light does not work on your B&D Door Opening System, the LED has failed. Change the LED.
Provides an alternative method for mounting the opener to a structural timber support.
Fine-tunes the opener's position for accurate door operation and limit setting.
Defines the fully open and fully closed positions for the garage door.
Covers resetting limits, factory defaults, and setting the PET mode.
Essential safety feature to prevent door closing on obstructions.
Automatically closes the door after a set time if safety beams are clear.
Enables control of external devices like alarms or other openers.
Programming remote control transmitters to operate the opener.
Assigns a transmitter button to control the opener's courtesy light.
Sets the opener to respond only to a specific transmitter button.
Assigns a transmitter button to activate the auxiliary output.
Codes a transmitter button to control the PET mode for partial door opening.
Instructions for mounting and coding a wall-mounted transmitter unit.
Codes new transmitters using an already programmed transmitter.
Deletes all previously programmed transmitter codes from the opener.
General| Brand | B&D |
|---|---|
| Model | PanelPro |
| Category | Door Opening System |
| Language | English |
To Next Page
