B&D Smart Pro SDO-9V3 - User Manual

www.bnd.com.au
Sectional Door Opener
installation instructions
Smart Pro, Smart
& Secure
These instructions are intended for professional garage door
opener installers.
All references are taken from inside looking out.
DOC# 161083_01
RELEASED: 15/12/22
Smart Pro, Smart & Secure
(SDO-9V3, SDO-7V3 & SDO-6V3)

Summary

Safety Warnings for Installation

Before You Begin Installation

Examine Garage Conditions

Examine garage conditions like ceiling and wall type before installation.

Pre-Installation Door Tests

Test door operation, balance, and force before starting opener installation.

Tools Required for Installation

Kit Contents Overview

Opener Positioning

Fitting the Garage Door Opener

Bracket Mounting Position

Perforated Angle Installation

Mounting Brackets and Arms

Safety Beam Kit Installation

Technical Specifications

Setting Operational Limits

Set Limit Positions and Adjust Drive Speed

Procedure to set door open and close limits, and adjust drive speed.

Clear Door Limit Positions

Steps to clear previously set door limit positions.

Re-profile the Door

Re-learn door travel characteristics after mechanical adjustments.

Controller Memory Reset

Procedure to reset controller to factory defaults.

Safety Testing Procedures

Test the Close Cycle

Test if the door reverses correctly when obstructed during closing.

Test the Open Cycle

Test if the door stops when obstructed during opening.

Test Manual Door Operation

Checks for door balance, springs, and smooth manual operation.

Test Battery Backup

Test the functionality of the battery backup system.

Auto-Close and Accessories

Configure Auto-Close Mode

Configure automatic door closing after a set time or beam trigger.

Terminal Block Connections

Details the terminal block connections for wired accessories.

Connect or Disconnect Accessories

Instructions for connecting and managing up to 4 accessories.

Battery Backup Functionality

Explanation of battery backup functionality and limitations.

Coding a Transmitter

Store Transmitter Code

Procedure to program remote controllers into the opener's memory.

Remotely Code Transmitters

Method for duplicating remote control codes from a pre-coded remote.

Erase All Transmitter Codes

Steps to erase all programmed transmitter codes.

Activate Vacation Mode

Enables or disables vacation mode for transmitters.

Install Wall Mounted Transmitter

Guide for mounting the wall-mounted transmitter unit.

Smart Phone Control Setup

Opener Safety and Security

Opener Cannot Operate Door Conditions

Conditions under which the opener cannot operate the door.

Manual Door Operation Conditions

Situations where the door can be operated manually.

Disengage Opener Procedure

Procedure to manually disengage the opener from the door.

Re-engage Opener Procedure

Procedure to re-engage the opener with the door.

Operating the Garage Door Opener

Basic Opener Operation

Instructions on how to operate the door using the transmitter.

User Operating Controls

Troubleshooting Guide

After Installation Care and Servicing

Service Checklist

Regular service checklist for maintaining the garage door opener.

Battery Replacement

Steps for replacing the transmitter battery.

Battery Disposal Guidelines

Guidelines for proper battery disposal and recycling.

Product Warranty Information

Information regarding product warranty conditions.

Appendix A: Status Indication

Adjustment Mode Instructions

Adjusting Force Margins

Adjusting safety obstruction force due to environmental factors.

Battery Functions Explained

Details on battery shutdown and testing functions.

Setting PET Mode Position

Procedure to set a preset position for PET mode.

Setting Limits via Transmitter

Setting Up Tilt Door Profile

B&D Smart Pro SDO-9V3 Specifications

General

Brand	B&D
Model	Smart Pro SDO-9V3
Category	Door Opening System
Language	English