Bandit 2290 - Page 19

Bandit
17Copyright 8/19
MODEL 2290
LOCATION NUMBER DESCRIPTION
DECALS
DECAL LOCATIONS
Modications and/or additions of decals to this list will happen.
Consult chipper dealer or manufacturer for most current decal package.
1. SPD-02 Moving Parts...
2. SPD-03 Lock out all Energy...
3. SPD-04 Flying Discharge Material...
4. SPD-15 Loader Arm
5. SPD-16 Do Not Hand Feed...
6. SPD-19 Entanglement
7. SPD-20 Flying Objects Stand Clear...
8. SPD-22 Emergency Shut Down Only
9. SPD-25 Stand Clear - Moving Conveyor
10. SPD-28 Do Not Insert Fingers
11. SPD-29 Do Not Climb or Reach Into Infeed Conveyor...
12. SPD-30 Do Not Sit, Stand, Lay, Climb...
13. SPD-32 Do Not Operate This Machine...
14. SPD-33 Do Not Work Under...
15. ID-67 Made in USA
16. INST-01 Remove To Check Torque...
17. INST-02 Yoke Lock Hole
18. INST-03 Yoke Lock Bar
19. INST-04 Arrow
20. INST-10 Stabilizer Down / Up.
21. INST-12 Grease Daily (Arrow)
22. INST-44 Proposition 65
23. INST-45 For Parts and Service...
24. INST-53 Hydraulic Oil...Hydrex XV...
25. INST-75 Hydraulic Oil For “PT Tech” Clutch...
26. INST-90 Tongue Down / Up
27. INST-92 Air Brake Release
28. INST-95 Electric Plug-In Schematic
29. INST-100 Lubricate Cutter Head Bearings...
30. INST-101 Canada Engine Decal
31. INST-185 Yoke Lock Instructions
32. INST-222 Electrical Plug Diagram
33. INST-355 80W90
34. N-02 Maintain Lubrication...
35. N-03 Service Required Under Beltshield...
36. N-05 Frequently Adjust...PTO...
37. SPN-06 Decal Maintenance...
38. N-07 Clutch Operation...
39. N-09 Adjustable Feed Speed...
40. SPN-11 Correct Knife And Hardware...
41. SPN-14 Do Not Start To Weld...Unless...
42. SPN-16 24 Volt Circuit
43. SPN-17 Battery Disconnect Switch O󰀨 (Arrow) On
44. SPN-20 Maximum Towing Speed 55 MPH (88 KPH)
45. N-30 Must Wait 2...Before Turning O󰀨 Battery...
Some decals are for optional equipment. Decal locations may vary, these are general
locations. If any decals become damaged, replace immediately.
NOTICE