Bandit 2290 - Page 23

Bandit
21Copyright 8/19
MODEL 2290
LOCATION NUMBER DESCRIPTION
DECAL LOCATIONS
Modications and/or additions of decals to this list will happen.
Consult chipper dealer or manufacturer for most current decal package.
DECALS
1. SPD-02 Moving Parts...
2. SPD-03 Lock out all Energy...
3. SPD-04 Flying Discharge Material...
4. SPD-16 Do Not Hand Feed...
5. SPD-17 Do Not Run Or Operate...With Door/Compartment Open...
6. SPD-19 ...Minimum 10 Feet Away From Tracks...
7. SPD-20 Flying Objects Stand Clear...
8. SPD-25 Stand Clear - Moving Conveyor
9. SPD-28 Do Not Insert Fingers
10. SPD-29 Do Not Climb or Reach Into Infeed Conveyor...
11. SPD-30 Do Not Sit, Stand, Lay, Climb...
12. SPD-32 Do Not Operate This Machine...
13. SPD-33 Do Not Work Under...
14. ID-67 Made in USA
15. INST-02 Yoke Lock Hole
16. INST-03 Yoke Lock Bar
17. INST-04 Arrow
18. INST-12 Grease Daily (Arrow)
19. INST-44 Proposition 65
20. INST-45 For Parts and Service...
21. INST-48 Disc/Drum Lock Tube
22. INST-49 Disc/Drum Lock Pin
23. INST-53 Hydraulic Oil...Hydrex XV...
24. INST-75 Hydraulic Oil For “PT Tech” Clutch...
25. INST-91 Lubricant For “Twin Disc” Hydraulic Clutch...
26. INST-100 Lubricate Cutter Head Bearings...
27. INST-101 Canada Engine Decal
28. INST-185 Yoke Lock Instructions
29. INST-355 80W90 Lube
30. N-02 Maintain Lubrication...
31. N-03 Service Required Under Beltshield...
32. N-05 Frequently Adjust...PTO...
33. SPN-06 Decal Maintenance...
34. N-07 Clutch Operation...
35. N-09 Adjustable Feed Speed...
36. SPN-11 Correct Knife And Hardware...
37. SPN-14 Do Not Start To Weld...Unless...
38. SPN-16 24 Volt Circuit
39. SPN-17 Battery Disconnect Switch O󰀨 (Arrow) On
40. SPN-36 12 Volt Circuit
41. N-30 Must Wait 2...Before Turning O󰀨 Battery...
42. N-51 Battery Instructions
43. N-54 PT Tech Clutch Disconnect...
44. N-69 Patents....
45. SPW-01 Do Not Go Near Oil Leaks...
Some decals are for optional equipment. Decal locations may vary, these are general
locations. If any decals become damaged, replace immediately.
NOTICE