CONTROLS
If the discharge or hood need to be removed, always use some sort of mechanical device like an overhead
hoist, loader, lift truck, etc. that is rated for lifting that component. Follow all OSHA instructions for lifting.
Before attempting any type of maintenance, disengage clutch, wait for the disc/drum to come to a complete
stop, turn o engine, remove the ignition key, make sure the ignition key is in your possession, install the
disc/drum lock pin, wait 2 minutes and then disconnect the battery.
There are two air vents on each side of the drum housing of your machine. The air vents can be opened
or closed to adjust your chip throwing to your particular application. The chip throwing distance has many
variables for example: type of material chipping, size of material chipping, the machine engine size, if machine
is equipped with autofeed or not, etc.
Before adjusting the air vents; disengage clutch, turn o engine, wait for the drum to come to a complete
stop, install the drum lock pin, disconnect battery, and make sure the ignition key is in your
possession.
To Next Page
Loading...
