Bandit 2290 - Page 37

Bandit
33Copyright 8/19
MODEL 2290 CONTROLS
Front Stabilizer Control
CONTROLS
Front Stabilizer Control Valve:
NOTE: Remove the lock pin BEFORE operating this function.
The front stabilizer control valve operates both front stabilizer cylinders. To raise the front of the machine,
push the control handle away from you, towards the machine. To lower the front of the machine, pull the control
handle towards you, away from the machine. The stabilizer control valve is the o󰀨 position in the center position.
Rear Stabilizer Control Valve:
NOTE: Remove the lock pin BEFORE operating this function.
The rear stabilizer control valve operates the rear stabilizer cylinder, there will be one valve on each side
of the machine near the rear stabilizer. To lower the rear stabilizer, push the control handle away from you,
towards the machine. To lift the rear stabilizer, pull the control handle towards you, away from the machine.
The rear stabilizer control valve is in the o󰀨 position in the center position.
Rear Stabilizer Control