Bandit 2290 - Page 53

Bandit
49Copyright 8/19
MODEL 2290 MAINTENANCE
1. Check anvil clearance, tightness, and wear.
2. Check alternator and fan belts on engine, adjust or replace.
3. Check and retighten wheel lug nuts (if equipped).
4. Keep pump bearings block(s) full of gear lube (if equipped).
5. Lubricate steel friction areas: pivoting, hinged, sliding, & rotating areas
(i.e. conveyor chain, cabinet doors, discharge, discharge ipper, engine adjusters, etc).
6. Use a dry lube on any chain driven component.
7. Check the condition of the stick breakers. Sharpen or replace as necessary.
WEEKLY CHECK LIST
Every week these checks must be made:
OK REPAIRED
MONTHLY CHECK LIST
1. Grease drum head bearings every 120 hours or monthly with 16 pumps of
Mobil 1 Universal Synthetic grease, Mobil SHC 220 Synthetic grease,
Mobil AW2 Synthetic grease, or Amsoil Multi-Purpose Grease NLGI#2..
2. Check towing hitch for wear, keep pintle ring or 5th wheel greased.
3. Check discharge, and infeed hopper for wear.
4. Inspect feedwheel motor connection, sprockets, and bushings.
5. Check feedwheel teeth for sharpness.
6. Check infeed conveyor chain tightness and tracking.
7. Check and retighten bearing bolts, bearing lock collars, and sheave bushings.
8. Check connections and tightness of hydraulic pumps, motors, and gear boxes.
9. Check hydraulic function pressures. Set to specied PSI (bar).
10. Check and ll tires to rated pressure (if equipped).
11. Check and grease or oil wheel bearings, follow axle MFG. instructions (if equipped).
Every month these checks must be made:
OK REPAIRED
1. Replace hydraulic lter(s) after rst 10 hours then quarterly or every 400 hours.
2. Replace high pressure oil lter quarterly or every 400 hours.
3 MONTH CHECK LIST
Every three months these checks must be made:
OK REPAIRED
1. Pack the female splines of the bearing block(s) with grease.
2. Change gear lube in feedwheel gear box.
3. Change gear lube in infeed conveyor gear box.
6 MONTH CHECK LIST
Every six months these checks must be made:
OK REPAIRED
1. Change hydraulic oil and ush the hydraulic tank.
2. Replace hydraulic suction screen(s) annually or every 2000 hours.
3. Drain and clean the fuel tank.
4. Remove all grease from drum head bearings, repack and ll housing 1/2 full.
YEARLY CHECK LIST
Every six months these checks must be made:
OK REPAIRED